Home › TRANSMISSION ยท U140F AUTOMATIC TRANSAXLE › AUTOMATIC TRANSAXLE ASSEMBLY

AUTOMATIC TRANSAXLE ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
  1. for 1AZ-FE:
    Remove the engine with transaxle (Click here).

  1. for 2AZ-FE:
    Remove the engine with transaxle (Click here)



2. DRAIN AUTOMATIC TRANSAXLE FLUID
  1. Remove the drain plug and gasket, and drain ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    47 N*m{ 479 kgf*cm , 35 ft.*lbf }



3. REMOVE STARTER ASSEMBLY


A124920
  1. Disconnect the starter connector.

  1. Open the terminal cap, and remove the nut and disconnect the starter wire.



    C127843
  1. Remove the 2 bolts and starter.



4. DISCONNECT WIRE HARNESS


C127821
  1. Disconnect the park/neutral position switch connector.

  1. Disconnect the transaxle wire connector.

  1. Disconnect the 2 speed sensor connectors.

  1. Disconnect the wire harness clamps.



5. REMOVE TRANSMISSION OIL COOLER (w/ Warmer)
  1. Remove the oil cooler .



6. REMOVE TRANSMISSION OIL COOLER HOSE AND TUBE (for Water Cooled)
  1. Remove the oil cooler hoses and tube (Click here).



7. REMOVE ENGINE MOUNTING BRACKET RR


C130913
  1. Remove the 3 bolts and mounting bracket.



8. REMOVE ENGINE MOUNTING BRACKET FR


C130912
  1. w/ Warmer:
    Remove the 4 bolts and mounting bracket.



    C130924
  1. for Water cooled:
    Remove the 3 bolts and mounting bracket.



9. REMOVE ENGINE MOUNTING BRACKET LH


C129380
  1. Remove the 3 bolts and mounting bracket.



10. REMOVE TRANSFER ASSEMBLY


    C126622
  1. except K111F:
    Remove the 6 nuts, 2 bolts and transfer from the transaxle.



    C130224
  1. for K111F:
    Remove the 6 nuts and transfer from the transaxle.



11. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY


C127819
  1. Remove the flywheel housing under cover.

  1. Turn the crankshaft to gain access and remove the 6 bolts while holding the crankshaft pulley bolt with a wrench.



    C127820
  1. Remove the 4 lower side mounting bolts.



    C127822
  1. Remove the 5 upper side mounting bolts.

  1. Separate and remove the automatic transaxle.



12. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY


C133010E01
  1. Remove the ATF dipstick.

  1. Remove the bolt and oil filler tube.



13. REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET


C133011E01
  1. Remove the 2 bolts and cable bracket.



14. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY