ACTIVE TORQUE CONTROL 4WD SYSTEM > 4WD Indicator Light Remains ON |

| 1.CHECK FOR DTC |
Check the output DTC (Click here).
| Result | Proceed to | ||
| Neither CAN communication system DTC nor 4WD control system DTC is output | A | ||
| CAN communication DTC is output | B | ||
| 4WD control system DTC is output | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK WIRE HARNESS (4WD CONTROL ECU - BATTERY) |
![]() |
Disconnect the E67 ECU connector.
Measure the voltage of the wire harness side connector.
| Tester Connection | Condition | Specified Condition | |||
| E67-11 (IG1) - Body ground | Ignition switch on (IG) | 10 to 14 V | |||
|
| ||||
| OK | |
| 3.CHECK COMBINATION METER |
Check the combination meter (Click here).
|
| ||||
| OK | ||
| ||