Home › TRANSMISSION ยท K111F CVT › TRANSAXLE OIL PAN

TRANSAXLE OIL PAN > INSTALLATION



1. INSTALL TRANSAXLE OIL PAN SUB-ASSEMBLY


C103348E01
  1. Install the 3 magnets to the oil pan.
    Text in Illustration 
    *1
    Magnet

  1. Install a new gasket to the oil pan.



    C200350
  1. Install the oil pan to the transaxle with the 19 bolts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

    NOTICE:
    Completely remove any oil or grease from the contact surface of the transaxle case and oil pan sub-assembly with gasket before installation.



2. INSTALL NO. 1 TRANSMISSION OIL FILLER TUBE
  1. Using a 6 mm socket hexagon wrench, install the No. 1 transmission oil filler tube to the oil pan.

    Torque:
    1.7 N*m{ 17 kgf*cm , 15 in.*lbf }



3. ADD CONTINUOUSLY VARIABLE TRANSAXLE FLUID
  1. Add continuously variable transaxle fluid (Click here).



4. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT LH


    A206203
  1. Install the reinforcement with the 4 bolts.

    Torque:
    96 N*m{ 979 kgf*cm , 71 ft.*lbf }



5. INSPECT FOR OIL LEAK


6. INSTALL REAR ENGINE UNDER COVER LH


    A196893
  1. Install the under cover with the 2 clips.



7. INSTALL NO. 1 ENGINE UNDER COVER


    A206200
  1. Install the under cover with the 6 screws and 10 clips.