ENTRY AND START SYSTEM > Driver Side Door Entry Lock Function does not Operate |

| 1.CHECK FOR DTC |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
By following the tester screen display, check whether any DTCs are output.
|
| ||||
| OK | |
| 2.CHECK MANUAL DOOR LOCK OPERATION |
Check that all the doors lock when the door control switch (for manual operation) is turned to LOCK.
|
| ||||
| OK | |
| 3.CHECK WIRELESS DOOR LOCK CONTROL OPERATION |
Check that the wireless door lock and unlock functions operate normally (Click here).
|
| ||||
| OK | |
| 4.READ VALUE USING INTELLIGENT TESTER (DOOR LOCK POSITION SWITCH) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
Read the Data List according to the display on the intelligent tester.
| Item | Measurement Item / Range (Display) | Normal Condition | Diagnostic Note |
| D-Door Lock Pos SW | Driver side door lock position switch signal / ON or OFF | ON: Driver side door is unlocked OFF: Driver side door is closed | - |
|
| ||||
| OK | |
| 5.READ VALUE USING INTELLIGENT TESTER (LOCK SWITCH) |
Check the Data List for proper functioning of the door lock switch.
| Item | Measurement Item / Range (Display) | Normal Condition | Diagnostic Note |
| D-Door Trigger Switch | Driver side outside door handle (lock switch) / ON or OFF | ON: Lock switch is pushed OFF: Lock switch is not pushed | - |
|
| ||||
| OK | |
| 6.CHECK ECU AGGREGATION BOX (OPERATION) |
Temporarily replace the ECU aggregation box (certification ECU) with a new or normally functioning one.
Check that the entry lock and unlock functions operate normally (Click here).
|
| ||||
| OK | ||
| ||
| 7.INSPECT FRONT DOOR OUTSIDE HANDLE ASSEMBLY (for Driver Side) |
![]() |
Disconnect the front door outside handle (for driver side) connector.
Measure the resistance between the terminal when the trigger switch is operated.
| Tester Condition | Condition | Specified Condition |
| 1 - 3 | Switch released | 10 kΩ or higher |
| Switch pressed in | Below 1 Ω |
|
| ||||
| OK | ||
| ||