Home › BODY ELECTRICAL › WIPER AND WASHER › WASHER NOZZLE

WASHER NOZZLE > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY LH


  1. w/o Under Guard, w/ Under Guard:



      E179677
    1. Attach the 2 claws to install the headlight washer actuator sub-assembly.



    2. E179680
    3. Install the headlight washer actuator with the 2 screws.



  1. w/ Hood Moulding:



      E208569
    1. Attach the claw to install the headlight washer actuator sub-assembly with the headlight cleaner clamp as shown in the illustration.



    2. E208565
    3. Attach the 2 claws as shown in the illustration.



    4. E208566
    5. Push up the headlight cleaner clamp B to the surface of the bumper.



    6. E208567E01
    7. Install the headlight washer actuator sub-assembly with the clamp as shown in the illustration.
      Text in Illustration 
      *1
      Clamp
      *2
      Headlight Washer Actuator Sub-assembly LH
      *3
      Headlight Cleaner Clamp
      V100155
      Push Here



2. INSTALL HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



3. INSTALL HEADLIGHT WASHER NOZZLE SUB-ASSEMBLY LH


    E179681
  1. Attach the 2 claws to install the headlight washer nozzle.



4. INSTALL HEADLIGHT WASHER NOZZLE SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



5. INSTALL HEADLIGHT CLEANER HOSE


  1. w/o Under Guard:



      E179678
    1. Attach the 5 clamps to install the hose to the front bumper.

    2. Connect the clamp to the headlight washer hose.



  1. w/ Under Guard:



      E179679
    1. Attach the 5 clamps to install the hose to the front bumper.

    2. Connect the clamp to the headlight washer hose.



  1. w/ Hood Moulding:



      E208561
    1. Attach the 6 clamps to install the hose to the front bumper.

    2. Connect the clamp to the headlight washer hose.



6. INSTALL FRONT BUMPER COVER
  1. w/o Under Guard:
    Install the front bumper cover (Click here).

  1. w/ Under Guard:
    Install the front bumper cover (Click here).

  1. w/ Hood Moulding:
    Install the front bumper cover (Click here).



7. INSTALL RADIATOR SUPPORT OPENING COVER


B209240
  1. Install the radiator support opening cover with the 9 clips.



8. INSTALL FRONT FENDER LINER LH


    B133187
  1. Install the fender liner with the clip and fender liner retainer.

  1. Install the screw, nut and bolt.



9. INSTALL FRONT FENDER LINER RH

HINT:
Use the same procedures described for the LH side.



10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL