DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL > INSTALLATION |
| 1. INSTALL REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL |
Apply a light coat of MP grease to the lip of a new rear differential side gear shaft oil seal.
![]() |
Using SST and a hammer, tap the 2 rear differential side gear shaft oil seals into the rear differential carrier and differential side bearing retainer according to the specification.
| 2. INSTALL REAR DIFFERENTIAL CARRIER SUB-ASSEMBLY |
Install the differential carrier assembly (Click here).
| 3. ADD DIFFERENTIAL OIL |
Stop the vehicle on a level surface.
![]() |
Using a 10 mm socket hexagon wrench, remove the rear differential filler plug and gasket.
![]() |
Check that the oil level is between 0 to 5 mm (0 to 0.197 in.) from the bottom lip of the differential filler plug hole.
Using a 10 mm socket hexagon wrench, install a new gasket and the rear differential filler plug.