DIFFERENTIAL CARRIER ASSEMBLY > INSTALLATION |
| 1. INSTALL REAR DIFFERENTIAL SUPPORT |
![]() |
Install the differential support to the differential carrier with the 4 bolts.
| 2. INSTALL REAR DIFFERENTIAL NO. 1 AND NO. 2 SUPPORT |
![]() |
Install the differential No. 1 and No. 2 supports with the 4 bolts to the differential carrier.
| 3. INSTALL REAR DIFFERENTIAL DYNAMIC DAMPER |
Install the damper front side with the 2 bolts to the No. 1 support.
| 4. INSTALL DIFFERENTIAL CARRIER SUB-ASSEMBLY |
Support the rear differential carrier with a transmission jack or equivalent.
Apply hypoid gear oil to the splines of the left and right rear drive shaft inboard joints.
![]() |
Align the splines of the rear drive shaft inboard joints and, using a brass bar and hammer, tap in the left and right rear drive shafts.
![]() |
Slowly raise the transmission jack, install the 3 bolts.
Connect the connector.
![]() |
Install the breather tube.
Connect the harness clamp.
| 5. INSTALL REAR SUSPENSION MEMBER BRACE LH |
Install the member brace with the 2 bolts to the suspension member.
| 6. INSTALL REAR SUSPENSION MEMBER BRACE RH |
| 7. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY |
Install the propeller shaft assembly (Click here).
| 8. INSTALL EXHAUST PIPE ASSEMBLY |
Install the exhaust pipe for 1AZ-FE .
Install the exhaust pipe for 2AZ-FE .
Install the exhaust pipe for 1GR-FE .
Install the exhaust pipe for 3ZR-FAE (Click here).
| 9. INSTALL FUEL TANK ASSEMBLY |
Install the fuel tank for 1AZ-FE (Click here).
Install the fuel tank for 2AZ-FE (Click here).
Install the fuel tank for 2GR-FE (Click here).
Install the fuel tank for 3AZ-FAE (Click here).
| 10. ADD DIFFERENTIAL OIL |
Add the differential oil .