DIFFERENTIAL CARRIER ASSEMBLY > REMOVAL |
| 1. DRAIN DIFFERENTIAL OIL |
![]() |
Using a 10 mm socket hexagon wrench, remove the rear differential drain plug and gasket, and drain the oil.
Install a new gasket to the rear differential drain plug.
Using a 10 mm socket hexagon wrench, install the rear differential drain plug and gasket.
| 2. REMOVE REAR WHEEL |
| 3. REMOVE FUEL TANK ASSEMBLY |
Remove the fuel tank for 1AZ-FE (Click here).
Remove the fuel tank for 2AZ-FE (Click here).
Remove the fuel tank for 2GR-FE (Click here).
Remove the fuel tank for 3ZR-FAE (Click here).
| 4. REMOVE EXHAUST PIPE ASSEMBLY |
Remove the exhaust pipe assembly for 1AZ-FE .
Remove the exhaust pipe assembly for 2AZ-FE .
Remove the exhaust pipe assembly for 2GR-FE .
Remove the exhaust pipe assembly for 3ZR-FAE (Click here).
| 5. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY |
![]() |
Remove the 2 bolts and 2 adjusting washers, and disconnect the propeller with center bearing shaft.
![]() |
Place matchmarks on the differential carrier and propeller shaft.
Remove the 4 nuts and 4 washers, and disconnect the propeller shaft and differential carrier.
![]() |
Place matchmarks on the transfer and propeller shaft.
Remove the 4 nuts and 4 washers, and disconnect the propeller shaft from the transfer.
| 6. REMOVE REAR SUSPENSION MEMBER BRACE LH |
![]() |
Remove the 2 bolts and brace from the suspension member.
| 7. REMOVE REAR SUSPENSION MEMBER BRACE RH |
| 8. REMOVE DIFFERENTIAL CARRIER SUB-ASSEMBLY |
Disconnect the harness clamp.
Remove the breather tube.
![]() |
Disconnect the connector.
Support the rear differential carrier with a transmission jack or equivalent.
![]() |
Remove the bolt labeled A and bolt labeled B.
![]() |
Slowly lower the jack and then tilt the rear differential carrier.
![]() |
Set the tip of the tire lever to the position on the rear drive shaft inboard joint shown in the illustration. Then, using the ribbed part of the rear differential carrier as a fulcrum, disconnect the left and right rear drive shafts.
| 9. REMOVE REAR DIFFERENTIAL NO. 1 AND NO. 2 SUPPORT |
![]() |
Remove the 4 bolts and differential No. 1 and No. 2 supports from the differential carrier.
| 10. REMOVE REAR DIFFERENTIAL SUPPORT |
![]() |
Remove the 4 bolts and differential support from the differential carrier.
| 11. REMOVE REAR DIFFERENTIAL DYNAMIC DAMPER |
![]() |
Remove the 2 bolts and damper (front side) from the No. 1 support.