Home › DRIVE LINE › DIFFERENTIAL › DIFFERENTIAL CARRIER ASSEMBLY

DIFFERENTIAL CARRIER ASSEMBLY > REMOVAL

for Preparation Click here



1. DRAIN DIFFERENTIAL OIL


    C109019
  1. Using a 10 mm socket hexagon wrench, remove the rear differential drain plug and gasket, and drain the oil.

  1. Install a new gasket to the rear differential drain plug.

  1. Using a 10 mm socket hexagon wrench, install the rear differential drain plug and gasket.



2. REMOVE REAR WHEEL


3. REMOVE FUEL TANK ASSEMBLY
  1. for 1AZ-FE:
    (Click here)

  1. for 2AZ-FE:
    (Click here)

  1. for 2GR-FE:
    (Click here)

  1. for 3ZR-FAE:
    (Click here)



4. REMOVE EXHAUST PIPE ASSEMBLY
  1. for 1AZ-FE:

  1. for 2AZ-FE:

  1. for 2GR-FE:

  1. for 3ZR-FAE:
    (Click here)



5. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY


    C127524
  1. Remove the 2 bolts and 2 adjusting washers, and disconnect the propeller with center bearing shaft.

    NOTICE:
    1. During the removal, do not exert excessive force on the universal joint.
    2. When removing, transporting or storing the propeller with center bearing shaft assembly, do not allow the No. 2 joint angle to exceed 20°.



    C127525E01
  1. Place matchmarks on the differential carrier and propeller shaft.

  1. Remove the 4 nuts and 4 washers, and disconnect the propeller shaft and differential carrier.



    C127526E01
  1. Place matchmarks on the transfer and propeller shaft.

  1. Remove the 4 nuts and 4 washers, and disconnect the propeller shaft from the transfer.



6. REMOVE REAR SUSPENSION MEMBER BRACE LH


C127572
  1. Remove the 2 bolts and brace from the suspension member.



7. REMOVE REAR SUSPENSION MEMBER BRACE RH

HINT:
Use the same procedures described for the LH side.



8. REMOVE DIFFERENTIAL CARRIER SUB-ASSEMBLY
  1. Disconnect the harness clamp.

  1. Remove the breather tube.



    C127575
  1. Disconnect the connector.

  1. Support the rear differential carrier with a transmission jack or equivalent.



    C129479E01
  1. Remove the bolt labeled A and bolt labeled B.



    C129480
  1. Slowly lower the jack and then tilt the rear differential carrier.



    C231109E01
  1. With ribs:
    Set the tip of the tire lever to the position on the rear drive shaft inboard joint shown in the illustration. Then, using the ribbed part of the rear differential carrier as a fulcrum, disconnect the left and right rear drive shafts.

    NOTICE:
    Do not scratch the rear drive shaft dust cover.



    C228112
  1. Without ribs:
    Set the tip of a wheel nut wrench to the position on the rear drive shaft inboard joint shown in the illustration. Then, using a brass bar as a fulcrum, disconnect the left and right rear drive shafts.

    NOTICE:
    Do not scratch the rear drive shaft dust cover.



9. REMOVE REAR DIFFERENTIAL NO. 1 AND NO. 2 SUPPORT


    C127578
  1. Remove the 4 bolts and differential No. 1 and No. 2 supports from the differential carrier.



10. REMOVE REAR DIFFERENTIAL SUPPORT


    C127579
  1. Remove the 4 bolts and differential support from the differential carrier.



11. REMOVE REAR DIFFERENTIAL DYNAMIC DAMPER


    C127577
  1. Remove the 2 bolts and damper (front side) from the No. 1 support.