Home › SUSPENSION & AXLE › SUSPENSION › REAR NO. 1 SUSPENSION ARM

REAR NO. 1 SUSPENSION ARM > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. TEMPORARILY INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY LH


    C127555
  1. Temporarily install the suspension arm with the bolt and 2 nuts to the suspension member and axle carrier.



2. TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH
  1. Temporarily install the bracket to the shock absorber lower side with the bolt and nut.

    NOTICE:
    Fix the nut in place and temporarily install the bolt.



    C127561
  1. Temporarily install the shock absorber upper side to the suspension member with the bolt and nut.

    NOTICE:
    Fix the nut in place and temporarily install the bolt.



    C129929
  1. Install the shock absorber with the 2 bolts to the axle carrier.

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }



3. INSTALL REAR WHEEL
  1. Install the wheel.

    Torque:
    103 N*m{ 1050 kgf*cm , 76 ft.*lbf }



4. TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY
  1. Install the nut and 2 bolts.

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf } for bolt
    100 N*m{ 1020 kgf*cm , 74 ft.*lbf } for nut

    NOTICE:
    For the nut on the rear suspension member side, do not tighten the nut.



5. TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH
  1. For the shock absorber upper and lower side, fix the 2 nuts in place and tighten the 2 bolts.

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }



6. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
  1. Inspect and adjust the rear wheel alignment (Click here).