Home › SUSPENSION & AXLE › SUSPENSION › REAR NO. 1 SUSPENSION ARM

REAR NO. 1 SUSPENSION ARM > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. TEMPORARILY INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY LH


    C226957
  1. Temporarily install the suspension arm with a new nut to the axle carrier.



    C226958
  1. Insert the rear suspension toe adjust cam subassembly from the rear of the vehicle to install the rear No. 1 suspension arm assembly LH, and then temporarily install the No. 2 camber adjust cam with the nut.



    C226957
  1. Tighten the nut.

    Torque:
    100 N*m{ 1020 kgf*cm , 74 ft.*lbf }



2. TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH
  1. Temporarily install the bracket to the shock absorber lower side with the bolt and nut.

    NOTICE:
    Fix the nut in place and temporarily install the bolt.



    C127561
  1. Temporarily install the shock absorber upper side to the suspension member with the bolt and nut.

    NOTICE:
    Fix the nut in place and temporarily install the bolt.



    C129929
  1. Install the shock absorber with the 2 bolts to the axle carrier.

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }



3. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Press down on the vehicle several times to stabilize the suspension.



4. TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY


    C226958
  1. Tighten the nut.

    Torque:
    120 N*m{ 1224 kgf*cm , 89 ft.*lbf }

    NOTICE:
    Align the matchmarks on the rear suspension member and adjust cam.



5. TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH
  1. For the shock absorber upper and lower side, fix the 2 nuts in place and tighten the 2 bolts.

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }



6. INSTALL REAR WHEEL
  1. Install the wheel.

    Torque:
    103 N*m{ 1050 kgf*cm , 76 ft.*lbf }



7. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
  1. Inspect and adjust the rear wheel alignment (Click here).