REAR NO. 2 SUSPENSION ARM > INSTALLATION |
| 1. TEMPORARILY INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY LH |
![]() |
Temporarily install the No. 2 suspension arm to the suspension member with the bolt and nut.
| 2. INSTALL REAR COIL SPRING INSULATOR LOWER LH |
Install the insulator lower to the suspension No. 2 arm.
| 3. INSTALL REAR COIL SPRING LH |
Install the coil spring to the suspension No. 2 arm.
| 4. INSTALL REAR COIL SPRING INSULATOR UPPER LH |
Align the stopper part of the insulator upper with the coil spring tip, and install the insulator upper.
| 5. INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY LH |
![]() |
Slowly raise the jack, and install the No. 2 suspension arm to the axle carrier.
| 6. INSTALL REAR STABILIZER LINK ASSEMBLY LH |
![]() |
Install the stabilizer link with the 2 nuts.
| 7. CONNECT SKID CONTROL SENSOR WIRE (for 2WD) |
![]() |
Connect the skid control sensor wire connector (labeled A) to the skid control sensor.
Install the sensor clamp (labeled B) with the bolt (labeled C).
![]() |
Install the sensor clamps (labeled D) with the 2 nuts (labeled E).
Install the sensor clamp (labeled F) with the bolt (labeled G).
![]() |
Insert the connector and grommet into the inside of the vehicle through the passage hole in the wheel house.
![]() |
Hold the grommet and pull it toward the outside of the vehicle. Then fix the grommet in place so that it is not tilted.
![]() |
Connect the skid control sensor wire connector.
| 8. CONNECT REAR SPEED SENSOR LH (for 4WD) |
![]() |
Install the sensor (labeled A) with the bolt (labeled B).
Install the sensor clamp (labeled C) with the nut (labeled D).
![]() |
Install the sensor clamps (labeled E) with the 2 nuts (labeled F).
Install the sensor clamp (labeled G) with the bolt (labeled H).
![]() |
Insert the connector and grommet to the inside of the vehicle through the passage hole in the wheel house.
![]() |
Hold the grommet and pull it from the inside of the vehicle to the outside of the vehicle. Then fix it in place so that it is not tilted.
![]() |
Connect the speed sensor connector.
| 9. CONNECT NO. 2 PARKING BRAKE CABLE ASSEMBLY |
Connect the cable to the backing plate and parking brake shoe lever.
Pass the cable through the backing plate, and then connect the cable to the lever.
Install the cable to the backing plate with the bolt.

Install the clamp and clamp bolt (labeled F) to the trailing arm.
Install the clamp and clamp bolt (labeled E) to the rear suspension crossmember.
Install the clamp and clamp bolt (labeled D) to the crossmember.
Install the clamp and clamp bolt (labeled C) to the body.
Install the casing cap and casing cap bolt (labeled B) to the body.
Install the cable clamp (labeled A) to the body.
| 10. INSTALL REAR WHEEL |
Install the wheel.
| 11. STABILIZE SUSPENSION |
Lower the vehicle.
Press down on the vehicle several times to stabilize the suspension.
| 12. TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH |
Install the nut and 2 bolts.
| 13. INSPECT AND ADJUST REAR WHEEL ALIGNMENT |
Inspect and adjust the rear wheel alignment (Click here).