Home › ENGINE ยท 3ZR-FAE › LUBRICATION › LUBRICATION SYSTEM

LUBRICATION SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK ENGINE OIL LEVEL
  1. Warm up the engine, and then stop the engine and wait for 5 minutes.

  1. Check that the oil level is between the dipstick low level mark and full level mark.
    If the level is low, check for leakage and add oil up to the full level mark.

    NOTICE:
    Do not fill with engine oil above the full level mark.



2. CHECK ENGINE OIL QUALITY
  1. Check the oil for deterioration, water contamination, discoloration or thinning.
    If the quality is visibly poor, replace the engine oil and oil filter.



3. INSPECT OIL PRESSURE
  1. Remove the oil pressure switch .



    A154775E01
  1. Install an oil pressure gauge.
    Text in Illustration 
    *1
    Oil Pressure Gauge

  1. Warm up the engine.

  1. Measure the oil pressure.

    Standard Oil Pressure:
    Item
    Specified Condition
    Idle
    25 kPa (0.3 kgf/cm2, 3.6 psi) or higher
    3000 rpm
    150 to 400 kPa (1.5 to 4.1 kgf/cm2, 22 to 58 psi)

    If the oil pressure is not as specified, check the oil pump (Click here).

  1. Remove the oil pressure gauge.

  1. Install the oil pressure switch .

  1. Check for engine oil leaks.