Home › ENGINE ยท 2GR-FE › CHARGING › GENERATOR

GENERATOR > REMOVAL

for Preparation Click here



1. REMOVE RADIATOR ASSEMBLY
  1. Remove the radiator (Click here).



2. REMOVE FRONT WHEEL RH


3. REMOVE REAR ENGINE UNDER COVER RH
  1. Remove the 2 bolts, 4 screw, 10 clips and under cover.



4. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH


    A129514E01
  1. Remove the 4 bolts and reinforcement.



5. REMOVE RADIATOR RESERVOIR TANK


    A124838
  1. Remove the 2 bolts, 2 hoses and reservoir tank.



6. REMOVE FAN AND GENERATOR V BELT


    A137895
  1. Rotate the tensioner pulley counterclockwise to loosen the belt tension. Then remove the V-ribbed belt.



    A095070E01
  1. While turning the belt tensioner counterclockwise, align its holes, and then insert a 5 mm bi-hexagon wrench into the holes to fix the V-ribbed belt tensioner in place.



7. REMOVE GENERATOR ASSEMBLY


    A132430
  1. Disconnect the 2 wire harness clamps.



    A132431
  1. Remove the terminal cap.

  1. Remove the nut and disconnect the generator wire from terminal B.

  1. Disconnect the generator connector from the generator.



    A132432E01
  1. Remove the bolt from the cylinder block.



    A132433
  1. Remove the 2 bolts and generator.