Home › ENGINE ยท 3ZR-FAE › ENGINE MECHANICAL › CYLINDER HEAD GASKET

CYLINDER HEAD GASKET > REMOVAL

for Preparation Click here



1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
  1. Remove the engine assembly with transaxle (Click here).



2. REMOVE CAMSHAFT HOUSING SUB-ASSEMBLY
  1. Remove the camshaft housing sub-assembly (Click here).



3. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    A207698
  1. Remove the 3 bolts and heat insulator.



4. REMOVE MANIFOLD STAY


    A207701
  1. Remove the 3 bolts and manifold stay.



5. REMOVE EXHAUST MANIFOLD


    A207702
  1. Remove the 5 nuts and exhaust manifold.

  1. Remove the exhaust manifold gasket.



6. REMOVE NO. 1 WATER BY-PASS PIPE


    A177452
  1. Remove the 2 bolts and water by-pass pipe.



7. REMOVE VALVE STEM CAP


    A150945
  1. Remove the 16 valve stem caps.

    HINT:
    Arrange the removed parts in the correct order.



8. REMOVE CYLINDER HEAD SUB-ASSEMBLY


    A150891E01
  1. Using a 10 mm bi-hexagon wrench, uniformly loosen and remove the 10 cylinder head bolts and 10 plate washers in several steps in the sequence shown in the illustration.

    NOTICE:
    1. Be careful not to drop washers into the cylinder head.
    2. Head warpage or cracking could result from removing the bolts in the wrong order.

  1. Using a screwdriver with its tip wrapped with tape, pry between the cylinder head and cylinder block, and remove the cylinder head.

    NOTICE:
    Be careful not to damage the contact surfaces of the cylinder head and cylinder block.



9. REMOVE CYLINDER HEAD GASKET


    A221761
  1. Remove the cylinder head gasket.