DTC C0273/13 Open in ABS Motor Relay Circuit |
DTC C0274/14 Short to B+ in ABS Motor Relay Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| C0273/13 | When either condition below is met:
|
|
| C0274/14 | When motor relay off, motor relay remains closed for 4 seconds or more. |
|
| 1.INSPECT FUSE (ABS1) |
Remove the ABS1 H-fuse from the engine room No. 1 relay block.
Measure the resistance of the fuse.
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (SKID CONTROL ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the A27 ECU connector.
Measure the voltage of the wire harness side connector.
| Tester Connection | Specified Condition |
| A27-23 (+BM) - Body ground | 11 to 14 V |
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| A27-2 (GND1) - Body ground | Below 1 Ω |
| A27-24 (GND2) - Body ground | Below 1 Ω |
|
| ||||
| OK | |
| 3.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (MOTOR RELAY) |
Select the Active Test, generate a control command, and then check that the motor relay operates.
| Tester Display | Test Parts | Control Range | Diagnostic Note |
| Motor Relay | Turns ABS motor relay | ON or OFF | Operating sound of motor can be heard |
|
| ||||
| OK | |
| 4.RECONFIRM DTC |
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at 6 km/h (4 mph) or more to activate the initial check.
Check if the same DTC(s) is output (Click here).
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||