DTC C0278/11 Open in ABS Solenoid Relay Circuit |
DTC C0279/12 Short to B+ in ABS Solenoid Relay Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| C0278/11 | When either condition below is met:
|
|
| C0279/12 | Immediately after ignition switch turned on, solenoid relay contact closed for 0.2 seconds or more when relay off. |
|
| 1.INSPECT FUSE (ABS2) |
Remove the ABS2 fuse from the engine room No. 1 relay block.
Measure the resistance of the fuse.
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (SKID CONTROL ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the A27 ECU connector.
Measure the voltage of the wire harness side connector.
| Tester Connection | Specified Condition |
| A27-1 (+BS) - Body ground | 11 to 14 V |
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| A27-2 (GND1) - Body ground | Below 1 Ω |
| A27-24 (GND2) - Body ground | Below 1 Ω |
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at 6 km/h (4 mph) or more to activate the initial check.
Check if the same DTC(s) is output (Click here).
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||