Home › ENGINE ยท 3ZR-FAE › EMISSION CONTROL › PCV VALVE

PCV VALVE > INSTALLATION

for Preparation Click here



1. INSTALL VENTILATION VALVE SUB-ASSEMBLY


    A092670E09
  1. Apply adhesive to 2 or 3 threads of the ventilation valve sub-assembly.

    Adhesive:
    Toyota genuine adhesive 1324, three bond 1324 or equivalent

    Text in Illustration 
    *1
    Adhesive



    A155426
  1. Using a 22 mm ball joint lock nut wrench, install the ventilation valve sub-assembly.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where ball joint lock nut wrench is combined with a torque wrench (Click here).



2. INSTALL INTAKE MANIFOLD
  1. Install the intake manifold (Click here).