DTC P2763 Torque Converter Clutch Pressure Control Solenoid Control Circuit High (Shift Solenoid Valve DSU) |
DTC P2764 Torque Converter Clutch Pressure Control Solenoid Control Circuit Low (Shift Solenoid Valve DSU) |
| DTC Code | DTC Detection Condition
| Trouble Area |
| P2763 |
|
|
| P2764 |
|
|

| 1.INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE DSU) |
![]() |
Disconnect the transmission wire connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 7 (DSU) - Body ground | 20°C (68°F) | 11 to 15 Ω |
| *1 | Component without harness connected (Transmission Wire) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - ECM) |
![]() |
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B32-59 (DSU) - Body ground | 20°C (68°F) | 11 to 15 Ω |
| *1 | Front view of wire harness connector (to ECM) |
|
| ||||
| OK | |
| 3.REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 4.PERFORM INITIALIZATION |
| Replaced Part |
|
Using the intelligent tester, perform reset memory, deceleration sensor 0 point calibration and CVT oil pressure calibration (Click here).
Check that no DTC is stored.
| NEXT | ||
| ||
| 5.REPLACE CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY |
Replace the continuously variable transaxle assembly (Click here).
| NEXT | |
| 6.PERFORM INITIALIZATION |
| Replaced Part |
|
Using the intelligent tester, perform reset memory, deceleration sensor 0 point calibration and CVT oil pressure calibration (Click here).
Check that no DTC is stored.
| NEXT | ||
| ||