Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for HDD)

NAVIGATION SYSTEM (for HDD) > Microphone Circuit between Microphone and Navigation Receiver Assembly

for Preparation Click here


DESCRIPTION

This circuit sends a microphone signal from the telephone microphone assembly to the navigation receiver assembly.
It also supplies power from the navigation receiver assembly to the telephone microphone assembly.

WIRING DIAGRAM


E182423E01


INSPECTION PROCEDURE

1.INSPECT NAVIGATION RECEIVER ASSEMBLY


    E179201E03
  1. Disconnect the E106 navigation receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    13 (MIN-) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    5 (MACC) - Body ground
    Ignition switch ACC
    4.75 to 5.25 V



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - MAP LIGHT)


    E179014E14
  1. Disconnect the E106 navigation receiver assembly connector.



    E130091E14
  1. Disconnect the R8 map light assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E106-5 (MACC) - R8-12 (ACC)
    Always
    Below 1 Ω
    E106-4 (MIN+) - R8-11 (MI1+)
    Always
    Below 1 Ω
    E106-13 (MIN-) - R8-10 (MIC-)
    Always
    Below 1 Ω
    E106-5 (MACC) - Body ground
    Always
    10 kΩ or higher
    E106-4 (MIN+) - Body ground
    Always
    10 kΩ or higher
    E106-13 (MIN-) - Body ground
    Always
    10 kΩ or higher
    E106-3 (SNS2) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE TELEPHONE MICROPHONE WITH ANOTHER AND CHECK
  1. Replace the telephone microphone with a normal one (Click here).

  1. Check if the same problem occurs again.



NG
REPLACE MAP LIGHT ASSEMBLY (Click here)
OK

END (TELEPHONE MICROPHONE IS FAULTY)