Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › AIR FUEL RATIO SENSOR
RM30B0U _51 Engine / Hybrid System _008971 2AR-FE ENGINE CONTROL _0049666 AIR FUEL RATIO SENSOR A

2AR-FE ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION


PROCEDURE

Hide 1.INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

A195396
0.667,1.906 0.906,1.906 0.906,1.906 1.24,1.542 true 0.948,0.26 1.26,0.448 0.313,0.188 10 *1 0.333,1.833 0.813,2.063 0.479,0.229 10 SST
*1 Fulcrum Length


a.

Using SST, install the air fuel ratio sensor to the exhaust manifold.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

HINT:
·

Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

Make sure SST and the wrench are connected in a straight line.

·

Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION




b.

Connect the air fuel ratio sensor connector.


Hide 2.INSTALL RADIATOR HOSE CLAMP