Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › HEATED OXYGEN SENSOR
RM30B0U _51 Engine / Hybrid System _008971 2AR-FE ENGINE CONTROL _0049667 HEATED OXYGEN SENSOR A

2AR-FE ENGINE CONTROL  HEATED OXYGEN SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

Perform "Inspection After Repairs" after replacing the heated oxygen sensor.

Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION


PROCEDURE

Hide 1.INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

A293401
2.719,1.969 2.979,2.135 false 3.01,2.073 3.323,2.26 0.313,0.188 10 SST 1.49,0.375 1.667,0.583 0.177,0.208 10 *1
*1 Fulcrum Length


a.

Using SST, install the heated oxygen sensor to the front No. 2 exhaust pipe sub-assembly.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

HINT:
·

Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

Make sure SST and the wrench are connected in a straight line.

·

Perform "Inspection After Repairs" after replacing the heated oxygen sensor.

Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION




b.

Connect the heated oxygen sensor connector.


Hide 2.INSTALL FRONT NO. 2 EXHAUST PIPE SUB-ASSEMBLY

a.

Install a new gasket to the front No. 2 exhaust pipe sub-assembly.


b.

Install the front No. 2 exhaust pipe sub-assembly to the center exhaust pipe assembly with the 2 bolts.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


Hide 3.INSTALL FRONT EXHAUST PIPE SUB-ASSEMBLY