1.DISCHARGE FUEL SYSTEM PRESSURE
2. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
4.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
5.REMOVE AIR CLEANER CAP SUB-ASSEMBLY
6.DISCONNECT FUEL HOSE BRACKET
| *1 | Clamp |
Remove the bolt and disconnect the fuel hose bracket.
If the fuel hose is detached from the clamp shown in the illustration, the clamp cannot be reused.
7.DISCONNECT FUEL TUBE SUB-ASSEMBLY
Do not forcibly bend, kink or twist the fuel tube sub-assembly.
Remove the No. 2 fuel pipe clamp, and then disconnect the fuel tube sub-assembly.
Click hereEngine / Hybrid System>2AR-FE FUEL>FUEL SYSTEM>PRECAUTION
8.DISCONNECT WIRE HARNESS
Disconnect the 4 fuel injector connectors.
Disconnect the 2 connectors.
Remove the 3 bolts and 3 wire harness brackets.
Detach the clamp and disconnect the wire harness.
9.REMOVE FUEL DELIVERY PIPE
Remove the 2 bolts, and then remove the fuel delivery pipe together with the 4 fuel injector assemblies.
Be careful not to drop the fuel injectors when removing the fuel delivery pipe.
Remove the 2 fuel delivery spacers from the cylinder head.
Remove the 4 injector vibration insulators from the cylinder head.
10.REMOVE FUEL INJECTOR ASSEMBLY
|
Pull Out |
Pull the 4 fuel injector assemblies out of the fuel delivery pipe.
Remove the O-ring.