1.INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY
| *1 | New O-Ring |
Apply a light coat of gasoline or spindle oil to a new O-ring, and then install the O-ring to the fuel pressure pulsation damper assembly.
Install the fuel pressure pulsation damper assembly with the 2 bolts.
Make sure that the O-ring is not cracked or jammed when installing the fuel pressure pulsation damper assembly.
2.CONNECT FUEL TUBE SUB-ASSEMBLY
3.CONNECT FUEL HOSE BRACKET
4.INSTALL AIR CLEANER CAP SUB-ASSEMBLY
5.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
7.INSPECT FOR FUEL LEAK