Home › Engine / Hybrid System › 2AR-FE COOLING › THERMOSTAT
RM30B0U _51 Engine / Hybrid System _009233 2AR-FE COOLING _0050391 THERMOSTAT A

2AR-FE COOLING  THERMOSTAT  INSTALLATION  


PROCEDURE

Hide 1.INSTALL THERMOSTAT

a.

Install a new gasket to the thermostat.


b.
A194954
2.5,1.833 2.25,1.833 2.25,1.833 1.563,0.896 true 1.583,0.615 1.583,0.083 1.583,0.083 1.75,0.083 false 1.448,0.625 1.448,0.104 1.448,0.104 1.24,0.104 false 1.021,0.01 1.333,0.167 0.313,0.156 10 10° 1.771,0.01 2.083,0.167 0.313,0.156 10 10° 2.542,1.76 2.854,1.917 0.313,0.156 10 *1
*1 Jiggle Valve


Install the thermostat with the jiggle valve facing upward.

HINT:

The jiggle valve may be set to within 10° on either side of the prescribed position.



Hide 2.INSTALL WATER INLET

a.

Install the water inlet with the 2 nuts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 3.CONNECT NO. 2 RADIATOR HOSE

a.

Connect the No. 2 radiator hose to the water inlet, and slide the hose clamp to secure it.


Hide 7.INSTALL NO. 1 ENGINE UNDER COVER

Hide 8.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY