The IDs of each tire pressure warning valve and transmitter are registered to the tire pressure warning ECU and receiver.
When the ECU detects that a transmitter ID code is not registered in the ECU, a DTC is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C2171/71 | Transmitter ID not Registered | Transmitter ID code is not registered. (When an ID code is unregistered for 3 minutes or more) | Tire pressure warning ECU and receiver |
When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.
It is necessary to perform initialization (Click here Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION) after registration (Click here Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
Check the values by referring to the table below.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Registered ID 1 Code | Registered ID1 code | min.: 0, max.: FFFFFFF* | ID No. registered for transmitter ID1 displayed | - |
| Registered ID 2 Code | Registered ID2 code | min.: 0, max.: FFFFFFF* | ID No. registered for transmitter ID2 displayed | - |
| Registered ID 3 Code | Registered ID3 code | min.: 0, max.: FFFFFFF* | ID No. registered for transmitter ID3 displayed | - |
| Registered ID 4 Code | Registered ID4 code | min.: 0, max.: FFFFFFF* | ID No. registered for transmitter ID4 displayed | - |
| Registered ID 5 Code | Registered ID5 code | min.: 0, max.: FFFFFFF* | ID No. registered for transmitter ID5 displayed | w/ Full Size Spare Tire |
*: Displayed only when the ID No. is not registered.
| Tester Display |
|---|
| Registered ID 1 Code |
| Registered ID 2 Code |
| Registered ID 3 Code |
| Registered ID 4 Code |
| Registered ID 5 Code |
The registered transmitter ID codes are displayed on the Techstream.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Register the transmitter IDs for all the wheels.
Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION
| Proceed to |
|---|
| NEXT |
NEXT
Perform initialization.
Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
Check the values by referring to the table below.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| ID 1 Tire Inflation Pressure | ID1 tire inflation pressure | min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 488.72 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 388.72kPa (3.9 kgf/cm2, 56 psi) |
Actual tire inflation pressure | If N/A is displayed, data has not been received.* |
| ID 2 Tire Inflation Pressure | ID2 tire inflation pressure | min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 488.72 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 388.72kPa (3.9 kgf/cm2, 56 psi) |
Actual tire inflation pressure | If N/A is displayed, data has not been received.* |
| ID 3 Tire Inflation Pressure | ID3 tire inflation pressure | min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 488.72 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 388.72kPa (3.9 kgf/cm2, 56 psi) |
Actual tire inflation pressure | If N/A is displayed, data has not been received.* |
| ID 4 Tire Inflation Pressure | ID4 tire inflation pressure | min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 488.72 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 388.72kPa (3.9 kgf/cm2, 56 psi) |
Actual tire inflation pressure | If N/A is displayed, data has not been received.* |
| ID 5 Tire Inflation Pressure | ID5 tire inflation pressure | min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 488.72 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 388.72kPa (3.9 kgf/cm2, 56 psi) |
Actual tire inflation pressure | ·
If N/A is displayed, data has not been received.* ·
w/ Full Size Spare Tire |
*: It may take a few minutes until the values are displayed.
When no "ID Tire Inflation Pressure" data has changed, reset the tire pressure to the appropriate specified value and rotate the tire 90 to 270 degrees. Then rapidly release the tire pressure and recheck the data.
| Tester Display |
|---|
| ID 1 Tire Inflation Pressure |
| ID 2 Tire Inflation Pressure |
| ID 3 Tire Inflation Pressure |
| ID 4 Tire Inflation Pressure |
| ID 5 Tire Inflation Pressure |
| Proceed to |
|---|
| All tire pressure readings are equal to specified values. |
| Tire pressure values are not displayed. |
All tire pressure readings are equal to specified values.
Tire pressure values are not displayed.