1.INSTALL TIMING CHAIN COVER OIL SEAL
Apply MP grease to the lip of a new oil seal.
Do not allow foreign matter to contact the lip of the oil seal.
Do not allow MP grease to contact the dust seal.
Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain cover edge.
Keep the lip of the oil seal free from foreign matter.
Do not tap in the oil seal at an angle.
2.INSTALL CRANKSHAFT PULLEY
3.INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH
4.INSTALL FAN AND GENERATOR V BELT
5.CONNECT RADIATOR RESERVOIR ASSEMBLY
6.INSTALL REAR ENGINE UNDER COVER RH
7.INSTALL NO. 1 ENGINE UNDER COVER