1.REMOVE NO. 1 ENGINE UNDER COVER
2.REMOVE REAR ENGINE UNDER COVER RH
3.DISCONNECT RADIATOR RESERVOIR ASSEMBLY
4.REMOVE FAN AND GENERATOR V BELT
5.REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH
6.REMOVE CRANKSHAFT PULLEY
7.REMOVE TIMING CHAIN COVER OIL SEAL
| *1 | Protective Tape |
Using a screwdriver, pry out the oil seal.
Do not damage the surface of the oil seal press fit hole or the crankshaft.
Tape the screwdriver tip before use.