Home › Engine / Hybrid System › 2AR-FE ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL
RM30B0U _51 Engine / Hybrid System _009173 2AR-FE ENGINE MECHANICAL _0050874 REAR CRANKSHAFT OIL SEAL A

2AR-FE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 4.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

a.
A195875
0.384,1.203 0.714,1.359 0.33,0.156 10 SST 0.779,1.272 0.934,1.272 0.934,1.272 1.322,1.143 false 1.238,0.738 0.934,1.272 false

Using SST, hold the crankshaft pulley.

SST
09213-54015  
91551-80650  
09330-00021  


b.
A238740

Remove the 8 bolts, front drive plate spacer, drive plate and ring gear sub-assembly and rear drive plate spacer.


Hide 5.REMOVE REAR ENGINE OIL SEAL

a.
A293109
2.813,1.646 2.813,1.521 2.813,1.521 3.083,1.01 false 2.188,1.979 2.042,1.979 2.042,1.979 1.156,1.5 true 2.74,1.667 3.052,1.823 0.313,0.156 10 false *1 2.24,1.885 2.417,2.042 0.177,0.156 10 false *2
*1 Cut Position
*2 Protective Tape


Using a knife, cut off the lip of the oil seal.


b.

Using a screwdriver, pry out the oil seal.

NOTICE:

Do not damage the surface of the oil seal press fit hole or the crankshaft.


HINT:

Tape the screwdriver tip before use.