Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR BELT MOULDING
RM30B0U _59 Vehicle Exterior _009441 EXTERIOR PANELS / TRIM _0051133 REAR DOOR BELT MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR BELT MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL REAR DOOR BELT MOULDING ASSEMBLY LH

a.

Attach the 8 claws to install the rear door belt moulding.


Hide 2.INSTALL REAR DOOR GLASS RUN LH

Hide 3.INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

Hide 4.INSTALL REAR DOOR QUARTER WINDOW GLASS LH

Hide 5.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

Hide 6.INSTALL REAR DOOR SERVICE HOLE COVER LH

Hide 7.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 8.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH

Hide 9.INSTALL DOOR ASSIST GRIP COVER LH

Hide 10.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Hide 11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION