Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
4.REMOVE DOOR ASSIST GRIP COVER LH
5.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH
6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
7.REMOVE REAR DOOR SERVICE HOLE COVER LH
8.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
9.REMOVE REAR DOOR QUARTER WINDOW GLASS LH
10.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
11.REMOVE REAR DOOR GLASS RUN LH
12.REMOVE REAR DOOR BELT MOULDING ASSEMBLY LH
13.REMOVE REAR DOOR WEATHERSTRIP LH
14.REMOVE DOOR WINDOW FRAME MOULDING CLIP
15.REMOVE REAR DOOR OUTSIDE MOULDING SUB-ASSEMBLY LH
16.REMOVE REAR DOOR OUTSIDE STRIPE LH
When removing the rear door outside stripe, heat the rear door panel and rear door outside stripe using a heat light.
| Item | Temperature |
|---|---|
| Rear Door Panel | 40 to 60°C (104 to 140°F) |
| Rear Door Outside Stripe | 20 to 30°C (68 to 86°F) |
Do not heat the rear door panel or rear door outside stripe excessively.
Pull back an edge of the rear door outside stripe and pull it parallel to the rear door panel to remove it.
17.REMOVE REAR DOOR LOWER OUTSIDE STRIPE LH
When removing the rear door lower outside stripe, heat the rear door panel and rear door lower outside stripe using a heat light.
| Item | Temperature |
|---|---|
| Rear Door Panel | 40 to 60°C (104 to 140°F) |
| Rear Door Lower Outside Stripe | 20 to 30°C (68 to 86°F) |
Do not heat the rear door panel or rear door lower outside stripe excessively.
Pull back an edge of the rear door lower outside stripe and pull it parallel to the rear door panel to remove it.