Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO ANTENNA HOLDER
RM30B0U _56 Audio / Visual / Telematics _009403 AUDIO / VIDEO _0051157 RADIO ANTENNA HOLDER A

AUDIO / VIDEO  RADIO ANTENNA HOLDER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE ROOF HEADLINING ASSEMBLY

Hide 4.REMOVE ROOF ANTENNA POLE SUB-ASSEMBLY

Hide 5.REMOVE AMPLIFIER ANTENNA ASSEMBLY

a.
E272820

Disconnect the connector.


b.

Remove the nut.


c.
B208915

Detach the 2 claws and remove the with holder antenna assembly.


Hide 6.REMOVE SATELLITE RADIO ANTENNA ASSEMBLY

a.
E272819

Disconnect the connector.


b.

Remove the nut.


c.
B208915

Detach the 2 claws and remove the with holder antenna assembly.