Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM30B0U _56 Audio / Visual / Telematics _009404 PARK ASSIST / MONITORING _0051188 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1ABB  Blind Spot Monitor Master Module Beam Axis Inspection Incomplete  


DESCRIPTION

This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor LH.

HINT:

This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.


DTC No. Detection Item DTC Detection Condition Trouble Area
C1ABB Blind Spot Monitor Master Module Beam Axis Inspection Incomplete A beam axis inspection has not been performed. Blind spot monitor sensor LH

PROCEDURE

1.PROCEED TO TEST MODE (BLIND SPOT MONITOR BEAM AXIS INSPECTION)
a.

Change the blind spot monitor sensor LH to Test Mode using the Techstream.

HINT:

Refer to Blind Spot Monitor Beam Axis Inspection.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK



Result:
Proceed to
NEXT



NEXT

END