Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB
RM30B0U _52 Drivetrain _009469 AXLE AND DIFFERENTIAL _0051191 FRONT AXLE HUB G

AXLE AND DIFFERENTIAL  FRONT AXLE HUB  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.


·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.DISCONNECT FRONT FLEXIBLE HOSE

Hide 3.DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH

Hide 4.REMOVE FRONT DISC

Hide 5.INSPECT FRONT AXLE HUB BEARING LOOSENESS

C130490

a.

Using a dial indicator, check for looseness near the center of the front axle hub sub-assembly.

Maximum:

0.05 mm (0.00197 in.)


NOTICE:

Make sure that the dial indicator is set perpendicular to the measurement surface.


If the looseness is more than the maximum, replace the front axle hub sub-assembly.


Hide 6.INSPECT FRONT AXLE HUB RUNOUT

C130489

a.

Using a dial indicator, check for runout on the surface of the front axle hub sub-assembly outside the front hub bolt.

Maximum:

0.05 mm (0.00197 in.)


NOTICE:

Make sure that the dial indicator is set perpendicular to the measurement surface.


If the runout is more than the maximum, replace the front axle hub sub-assembly.


Hide 7.INSTALL FRONT DISC

Hide 8.CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH

Hide 9.CONNECT FRONT FLEXIBLE HOSE

Hide 10.INSTALL FRONT WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)