Home › Suspension › REAR SUSPENSION › REAR COIL SPRING
RM30B0U _53 Suspension _009475 REAR SUSPENSION _0051209 REAR COIL SPRING A

REAR SUSPENSION  REAR COIL SPRING  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 2.REMOVE REAR STABILIZER LINK ASSEMBLY LH

Hide 3.LOOSEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH

C266840

a.

Loosen the 2 bolts of the suspension arm.

NOTICE:
·

Do not remove the bolts and nuts, only loosen them.

·

Since a stopper nut is used, loosen the bolt.




Hide 4.REMOVE REAR COIL SPRING LH

a.
C129671

Support the No. 2 suspension arm LH with a jack.

NOTICE:

Place a wooden or rubber block between the jack and arm.



b.
C129668

Remove the bolt located on the rear axle carrier of the rear No. 2 suspension arm.


c.

Lower the jack gradually to remove the rear coil spring together with the rear upper coil spring insulator.


Hide 5.REMOVE REAR UPPER COIL SPRING INSULATOR LH

a.

Remove the rear upper coil spring insulator from the rear coil spring.


Hide 6.REMOVE REAR LOWER COIL SPRING INSULATOR LH

a.

Remove the rear lower coil spring insulator from the rear No. 2 suspension arm.