Home › Suspension › REAR SUSPENSION › REAR TRAILING ARM
RM30B0U _53 Suspension _009475 REAR SUSPENSION _0051212 REAR TRAILING ARM A

REAR SUSPENSION  REAR TRAILING ARM  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.TEMPORARILY INSTALL REAR TRAILING ARM ASSEMBLY LH

a.

Temporarily install the rear trailing arm to the rear suspension arm bracket with the bolt and nut.


b.

Install the rear trailing arm to the vehicle with the 3 bolts.

Torque:
80 N*m (816 kgf*cm, 59 ft.*lbf)


c.

Install the rear trailing arm to the rear axle carrier with the 2 bolts.

Torque:
200 N*m (2039 kgf*cm, 148 ft.*lbf)


Hide 2.TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH

Hide 3.CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

a.

Connect the No. 3 parking brake cable to the rear trailing arm with the bolt.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)


Hide 5.TIGHTEN REAR TRAILING ARM ASSEMBLY LH

a.

Tighten the nut.

Torque:
150 N*m (1530 kgf*cm, 111 ft.*lbf)


Hide 6.TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH

Hide 7.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 8.INSPECT AND ADJUST REAR WHEEL ALIGNMENT