1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL
4.REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY
5.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL
6.REMOVE COMBINATION METER ASSEMBLY
Remove the 2 screws.
Detach the 2 clips and remove the combination meter assembly.
Disconnect the 2 connectors.