1.INSTALL NO. 4 INSTRUMENT PANEL CUSHION
Install a new No. 4 instrument panel cushion using adhesive or double-sided tape in the location shown in the illustration.
2.INSTALL NO. 1 INSTRUMENT PANEL CUSHION
Install 2 new No. 1 instrument panel cushions in the location shown in the illustration.
3.INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
4.INSTALL NO. 2 INSTRUMENT PANEL WIRE
5.INSTALL CENTER INSTRUMENT PANEL REGISTER CONNECTOR
Install the center instrument panel register connector with the 2 screws <A>.
6.INSTALL NAVIGATION ANTENNA ASSEMBLY (w/ Navigation System)
7.INSTALL NO. 2 INSTRUMENT PANEL WIRE
Attach the 8 wire harness clamps to install the No. 2 instrument panel wire.
8.INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY
Use the same procedure to install the No. 2 instrument panel register assembly on the other side.
Attach the 3 claws to install the No. 2 instrument panel register assembly.
9.INSTALL NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY
Install the No. 2 heater to register duct sub-assembly with the 2 screws <A>.
10.INSTALL NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY
Install the No. 1 heater to register duct sub-assembly with the 3 screws <A>.
11.INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH
Attach the 2 clips to install the instrument cluster finish panel garnish.
12.INSTALL BOX BOTTOM MAT
Install the box bottom mat.