1.REMOVE CENTER ROOF HEADLINING PAD
Remove the 2 center roof headlining pads.
2.REMOVE ROOF HEADLINING PAD
Use the same procedure for both roof headlining pads.
Remove the roof headlining pad.
3.REMOVE NO. 1 ROOF SILENCER PAD (w/o Sliding Roof)
Remove the 5 No. 1 roof silencer pads.
4.REMOVE NO. 1 ROOF SILENCER PAD (w/ Sliding Roof)
Remove the 2 No. 1 roof silencer pads.
5.REMOVE NO. 3 ROOF SILENCER PAD
Remove the No. 3 roof silencer pad.
6.REMOVE ROOF HEADLINING PAD RH
Remove the roof headlining pad RH.
7.REMOVE NO. 2 ROOF HEADLINING PAD
Remove the No. 2 roof headlining pad.
8.REMOVE VANITY LIGHT ASSEMBLY LH
| *1 | Bulb Holder |
Detach the 2 claws and disconnect the bulb holder from the vanity light assembly LH.
Detach the claw and remove the vanity light assembly LH.
9.REMOVE VANITY LIGHT ASSEMBLY RH
Use the same procedure described for the LH side.
10.REMOVE NO. 1 ROOF WIRE
w/o Sliding Roof:
Turn the 2 connectors approximately 90° clockwise and disconnect them.
Remove the one-sided tape.
Remove the remaining No. 1 roof wire from the double-sided tape.
| *A | w/ EC Mirror | *B | w/ Lane Departure Alert System |
| *a | 90° | - | - |
|
One-sided Tape | - | - |
w/ Sliding Roof:
Turn the 2 connectors approximately 90° clockwise and disconnect them.
Remove the one-sided tape.
Remove the remaining No. 1 roof wire from the double-sided tape.
| *A | w/ EC Mirror | *B | w/ Lane Departure Alert System |
| *a | 90° | - | - |
|
One-sided Tape | - | - |
Remove the remaining double-sided tape.
11.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY
12.REMOVE NO. 2 ROOF HEADLINING SUPPORT (w/o Sliding Roof)
Remove the No. 2 roof headlining support.
13.REMOVE NO. 2 ROOF HEADLINING SUPPORT (w/ Sliding Roof)
Remove the No. 2 roof headlining support.
14.REMOVE ROOF HEADLINING SUPPORT (w/o Sliding Roof)
Use the same procedure described for the No. 2 roof headlining support.
15.REMOVE ROOF HEADLINING SUPPORT (w/ Sliding Roof)
Use the same procedure described for the No. 2 roof headlining support.
16.REMOVE NO. 4 ROOF HEADLINING SUPPORT (w/ Sliding Roof)
Remove the No. 4 roof headlining support.
17.REMOVE NO. 3 ROOF HEADLINING SUPPORT (w/ Sliding Roof)
Use the same procedure described for the No. 4 roof headlining support.