Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO ANTENNA CORD(for Roof Side)
RM30B0U _56 Audio / Visual / Telematics _009403 AUDIO / VIDEO _0058385 RADIO ANTENNA CORD(for Roof Side) A

AUDIO / VIDEO  RADIO ANTENNA CORD(for Roof Side)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE ROOF HEADLINING ASSEMBLY

Hide 4.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY

a.

Apply masking tape to the No. 2 antenna cord sub-assembly.

HINT:

Apply the masking tape so that the edges of the masking tape and roof headlining are aligned as shown in the illustration.



b.

Remove the antenna cord from the roof headlining.

B336678
0.438,0.49 0.667,0.667 0.229,0.177 10 *A 0.438,2.833 0.75,2.99 0.313,0.156 10 *B
*A w/o Sliding Roof *B w/ Sliding Roof



c.

Remove the double-sided tape from the roof headlining.


Hide 5.REMOVE NO. 3 ANTENNA CORD SUB-ASSEMBLY

a.

Disconnect each connector.


b.

Remove the bolt.

B335965


c.

Detach the 3 clamps and remove the No. 3 antenna cord sub-assembly.