Home › Vehicle Interior › DOOR LOCK › BACK DOOR LOCK
RM30B0U _58 Vehicle Interior _009874 DOOR LOCK _0054294 BACK DOOR LOCK A

DOOR LOCK  BACK DOOR LOCK  INSTALLATION  


PROCEDURE

Hide 1.INSTALL BACK DOOR LOCK ASSEMBLY

NOTICE:
·

When installing a new back door lock assembly, if there is anytape stuck to it, remove the tape.

·

When installing a new back door lock assembly, if there are anystrings attached to it, cut the strings off.

·

Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.



a.

Apply MP grease to the sliding parts of the back door lock assembly.


b.
B339882

w/ Power Back Door:

i.

Attach the clamp to install the back door lock assembly.


ii.

Install the 4 bolts.

Torque:
except TMMC Made : 7.0 N*m (71 kgf*cm, 62 in.*lbf)
for TMMC Made : 8.0 N*m (82 kgf*cm, 71 in.*lbf)


iii.

Connect the connector.



c.
B337030

w/o Power Back Door:

i.

Install the back door lock assembly with the 3 bolts.

Torque:
except TMMC Made : 7.0 N*m (71 kgf*cm, 62 in.*lbf)
for TMMC Made : 8.0 N*m (82 kgf*cm, 71 in.*lbf)


ii.

Connect the connector.



Hide 2.INSTALL BACK DOOR TRIM BOARD ASSEMBLY

Hide 3.INSTALL BACK DOOR SIDE GARNISH LH

Hide 4.INSTALL BACK DOOR SIDE GARNISH RH

Hide 5.INSTALL BACK DOOR GARNISH CENTER