Home › Vehicle Interior › DOOR LOCK › FRONT DOOR LOCK
RM30B0U _58 Vehicle Interior _009874 DOOR LOCK _0054786 FRONT DOOR LOCK A

DOOR LOCK  FRONT DOOR LOCK  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS



PROCEDURE

Hide 1.INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

Hide 2.INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH

Hide 3.INSTALL FRONT DOOR WITH MOTOR LOCK ASSEMBLY LH

NOTICE:
·

When reusing the removed front door lock assembly, replace the door lock wiring harness seal on the connector with a new one.

·

Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.

·

Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water intrusion. This may result in a malfunction of the front door lock assembly.



a.

Apply MP grease to the sliding parts of the front door with motor lock assembly LH.


b.
B337013

Install a new door lock wiring harness seal to the front door with motor lock assembly LH.


c.
B337017
3.052,0.5 2.802,0.5 false 1.146,0.479 0.896,0.479 false 1.177,0.385 1.448,0.594 0.271,0.208 10 *1 3.073,0.417 3.344,0.625 0.271,0.208 10 *1
*1 Front Door Lock Open Rod LH
V100135

Upward


Insert the front door lock open rod LH into the front door with motor lock assembly LH.


d.

Make sure that the front door lock open rod is securely connected to the front door with motor lock assembly LH.


e.
B345346

Using a T30 "TORX" socket wrench, install the front door with motor lock assembly LH with the 3 screws.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


f.

Connect the connector.


Hide 4.INSTALL FRONT DOOR OUTSIDE HANDLE COVER LH (for Driver Side)

Hide 5.INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH

Hide 6.INSTALL FRONT DOOR GLASS RUN LH

Hide 7.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

Hide 8.INSTALL FRONT DOOR SERVICE HOLE COVER LH

Hide 9.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 10.INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

Hide 11.INSTALL DOOR ASSIST GRIP COVER LH

Hide 12.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

Hide 13.INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

Hide 14.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

Hide 15.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION