Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.INSTALL REAR SEAT BELT RETRACTOR COVER LH
Attach the claw to install the rear seat belt retractor cover LH.
2.INSTALL REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH
| *1 | Bolt (A) |
| *2 | Bolt (B) |
Align the 2 claws with the seat belt positioning holes, and install the retractor of the rear No. 1 seat outer belt assembly LH with the 2 bolts as shown in the illustration.
3.INSTALL INNER ROOF SIDE GARNISH ASSEMBLY LH
4.INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
5.CONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH
Connect the shoulder anchor of the rear No. 1 seat outer belt assembly LH with the bolt.
Check that the rear No. 1 seat outer belt assembly LH is not twisted.
Connect the floor anchor of the rear No. 1 seat outer belt assembly LH with the bolt.
Check that the rear No. 1 seat outer belt assembly LH is not twisted.
6.INSTALL SEAT BELT ANCHOR COVER CAP
Attach the guide and 2 claws to install the seat belt anchor cover cap.
7.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
8.INSTALL REAR DOOR SCUFF PLATE LH
9.INSTALL REAR SEAT ASSEMBLY LH
10.INSTALL REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE WITH REAR NO. 1 FLOOR BOARD
for Compact Spare Tire:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
for Full Size Spare Tire:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
11.INSTALL REAR DECK TRIM COVER (for Full Size Spare Tire)
12.INSTALL REAR FLOOR FINISH PLATE (for Compact Spare Tire)
13.INSTALL DECK FLOOR BOX LH
14.INSTALL DECK BOARD ASSEMBLY (for Full Size Spare Tire)
15.INSTALL DECK BOARD ASSEMBLY (for Compact Spare Tire)
16.INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
17.INSTALL PACKAGE TRAY TRIM POCKET SUB-ASSEMBLY (w/ Partition Net)