Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE PACKAGE TRAY TRIM POCKET SUB-ASSEMBLY (w/ Partition Net)
2.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
3.REMOVE DECK BOARD ASSEMBLY (for Compact Spare Tire)
4.REMOVE DECK BOARD ASSEMBLY (for Full Size Spare Tire)
5.REMOVE DECK FLOOR BOX LH
6.REMOVE REAR FLOOR FINISH PLATE (for Compact Spare Tire)
7.REMOVE REAR DECK TRIM COVER (for Full Size Spare Tire)
8.REMOVE REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE WITH REAR NO. 1 FLOOR BOARD
for Compact Spare Tire:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
for Full Size Spare Tire:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
9.REMOVE REAR SEAT ASSEMBLY LH
10.REMOVE REAR DOOR SCUFF PLATE LH
11.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
12.REMOVE SEAT BELT ANCHOR COVER CAP
Using a screwdriver, detach the 2 claws and guide to remove the seat belt anchor cover cap.
Tape the screwdriver tip before use.
13.DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH
Remove the bolt to disconnect the floor anchor of the rear No. 1 seat outer belt assembly LH.
Remove the bolt to disconnect shoulder anchor of the rear No. 1 seat outer belt assembly LH.
14.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
15.REMOVE INNER ROOF SIDE GARNISH ASSEMBLY LH
16.REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH
Remove the 2 bolts.
Detach the 2 claws to remove the rear No. 1 seat outer belt assembly LH.
17.REMOVE REAR SEAT BELT RETRACTOR COVER LH
Detach the claw to remove the rear seat belt retractor cover LH.