Perform these procedures after the engine has cooled down.
1.INSPECT DRIVE BELT
Inspect the drive belt.
Click hereEngine / Hybrid System>2AR-FE ENGINE MECHANICAL>DRIVE BELT>ON-VEHICLE INSPECTION
2.INSPECT ENGINE OIL
Inspect the engine oil.
3.REPLACE ENGINE OIL AND OIL FILTER
Replace the engine oil and oil filter.
4.INSPECT COOLING AND HEATER SYSTEM
Check that the radiator and condenser are not blocked with leaves, dirt or insects, and clean them if necessary. Also check the hose connection for the installation condition, corrosion, etc.
5.INSPECT ENGINE COOLANT
Inspect the engine coolant.
Click hereEngine / Hybrid System>2AR-FE COOLING>COOLING SYSTEM>ON-VEHICLE INSPECTION
6.REPLACE ENGINE COOLANT
Replace the engine coolant.
Click hereEngine / Hybrid System>2AR-FE COOLING>COOLANT>REPLACEMENT
7.INSPECT EXHAUST PIPES AND MOUNTINGS
Visually check the pipes, hangers and connections for severe corrosion, leaks or damage.
8.INSPECT BATTERY
Inspect the battery.
Click herePower Source / Network>2AR-FE BATTERY / CHARGING>CHARGING SYSTEM>ON-VEHICLE INSPECTION
9.REPLACE FUEL FILTER
Replace the fuel filter.
Click hereEngine / Hybrid System>2AR-FE FUEL>FUEL FILTER>REPLACEMENT
10.INSPECT AIR CLEANER FILTER ELEMENT
Remove the air filter.
Check that the air cleaner is not excessively dirty.
If the air cleaner is excessively dirty, replace the air cleaner filter element.
If cleaning the air cleaner filter element, blow compressed air as shown in the illustration to clean it.
Reinstall the air filter.
When an excessive amount of dirt is present, replace the air filter.
11.INSPECT FUEL LINES, CONNECTIONS, FUEL TANK VAPOR VENT SYSTEM HOSES AND FUEL TANK BANDS
Visually check the fuel lines and hoses for cracks, leaks, loose connections, or deformation.
Check for tank band looseness or deformation.
12.INSPECT FUEL TANK CAP GASKET
Check the fuel tank cap gasket.
Click hereEngine / Hybrid System>2AR-FE EMISSION CONTROL>FUEL TANK CAP>INSPECTION
13.REPLACE SPARK PLUGS
Replace the spark plugs.
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>IGNITION COIL AND SPARK PLUG>REMOVAL
14.INSPECT CHARCOAL CANISTER
Inspect the charcoal canister.
Click hereEngine / Hybrid System>2AR-FE EMISSION CONTROL>CANISTER>INSPECTION