Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type) › 2012.12–2013.11
RM30B0U _56 Audio / Visual / Telematics _009403 AUDIO / VIDEO _0054849 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  Touch Panel Switch does not Function  


CAUTION / NOTICE / HINT

NOTICE:

After replacing the radio and display receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary (w/ SDARS System).


PROCEDURE

1.CHECK DISPLAY
a.

Check if there is any foreign matter caught between the display and exterior frame of the display.

OK:

No foreign matter is caught between the display and exterior frame of the display.


HINT:

If there is foreign matter between the display and exterior frame of the display, the touch panel will remain pressed, preventing touch switch operation.



Result:
Proceed to
OK
NG



OK

2.CHECK TOUCH PANEL

NG

REMOVE FOREIGN MATTER

2.CHECK TOUCH PANEL
a.

Check for foreign matter on the display.


Result:
Proceed to
The display is clean
The display is not clean



The display is clean

3.CHECK TOUCH SWITCH (OPERATION CHECK)

The display is not clean

CLEAN DISPLAY AND RECHECK TOUCH PANEL

3.CHECK TOUCH SWITCH (OPERATION CHECK)
a.
E176521

Enter the "Touch Switch Check" screen. Refer to Check Touch Switch in Operation Check.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio and Display Type)>OPERATION CHECK


b.

Touch the display in the area where the switch malfunction occurs.


Result:
Proceed to
A "+" mark appears at the touched position
A "+" mark disappears at the touched position



A "+" mark appears at the touched position

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

A "+" mark disappears at the touched position