Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO RECEIVER › 2012.12–2013.11
RM30B0U _56 Audio / Visual / Telematics _009403 AUDIO / VIDEO _0058384 RADIO RECEIVER A

AUDIO / VIDEO  RADIO RECEIVER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL

Hide 4.REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 5.REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 6.REMOVE TELLTALE LIGHT ASSEMBLY

Hide 7.REMOVE RADIO RECEIVER ASSEMBLY

a.

Remove the 4 bolts.

E270077
0.417,0.427 0.833,0.583 0.417,0.156 10 *A 3.667,0.417 3.979,0.573 0.313,0.156 10 *B
*A for Radio Receiver Type *B for Radio and Display Type



b.

Detach the 4 clips and remove the radio receiver assembly with bracket.


c.

Disconnect each connector.


Hide 8.REMOVE NO. 1 RADIO BRACKET

a.

Remove the 3 screws and No. 1 radio bracket.

E270082
0.688,0.344 1,0.5 0.313,0.156 10 *A 3.521,0.344 3.833,0.5 0.313,0.156 10 *B
*A for Radio Receiver Type *B for Radio and Display Type



Hide 9.REMOVE NO. 2 RADIO BRACKET

a.

Remove the 3 screws and No. 2 radio bracket.

E270081
0.604,0.333 0.917,0.49 0.313,0.156 10 *A 3.417,0.344 3.729,0.5 0.313,0.156 10 *B
*A for Radio Receiver Type *B for Radio and Display Type