Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type) › 2012.12–2013.11
RM30B0U _56 Audio / Visual / Telematics _009403 AUDIO / VIDEO _0054849 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) C

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  B1551  HD Radio Tuner Malfunction  B158D  Video Signal Stoppage  B15A0  LAN Master Malfunction  B15B0  Display Screen Malfunction  B15B3  Radio Tuner Malfunction  B15B4  CD Changer Malfunction  B15B7  Bluetooth Module Malfunction  B15BA  XM Tuner Malfunction  


DESCRIPTION

These DTCs are stored when a malfunction occurs in the radio and display receiver assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1551 HD Radio Tuner Malfunction When one of the conditions below is met:
·

"HD Radio" tuner decoder malfunction

·

"HD Radio" tuner audio output section malfunction

·

"HD Radio" tuner decoder RF/IF malfunction


Radio and display receiver assembly
B158D Video Signal Stoppage The internal video signal of the radio and display receiver assembly is interrupted Radio and display receiver assembly
B15A0 LAN Master Malfunction When either condition below is met:
·

Bus malfunction

·

EEPROM error


Radio and display receiver assembly
B15B0 Display Screen Malfunction Picture circuit (TFT unit) malfunction Radio and display receiver assembly
B15B3 Radio Tuner Malfunction When one of the conditions below is met:
·

AM tuner PLL is unlocked

·

FM tuner PLL is unlocked

·

Tuner malfunction


Radio and display receiver assembly
B15B4 CD Changer Malfunction When one of the conditions below is met:
·

Mechanism drive signal malfunction

·

Load/Eject malfunction

·

Read mechanism malfunction

·

Mechanical malfunction


Radio and display receiver assembly
B15B7 Bluetooth Module Malfunction "Bluetooth" module malfunction Radio and display receiver assembly
B15BA XM Tuner Malfunction When either of the conditions below is met:
·

Internal IC malfunction

·

Tuner malfunction


Radio and display receiver assembly

CAUTION / NOTICE / HINT

NOTICE:

After replacing the radio and display receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary (w/ SDARS System).


PROCEDURE

1.CHECK FOR DTC
a.

Clear the DTCs.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio and Display Type)>DTC CHECK / CLEAR

Body Electrical > Navigation System > Clear DTCs
50002 212

b.

Recheck for DTCs and check that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes
50001 212

Result:
Proceed to
No DTCs are output
DTCs are output



No DTCs are output

DTCs are output

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY