The lane departure warning camera sends a buzzer request signal to the skid control buzzer assembly to sound the buzzer. When the lane departure warning camera detects a malfunction in the skid control buzzer circuit, the lane departure warning camera stores DTC C1AA7.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AA7 | Skid Control Buzzer Circuit | Both of the following conditions are met:
·
Skid control buzzer assembly on malfunction is detected for 240 ms or more. ·
Skid control buzzer assembly off malfunction is detected for 5 seconds or more. |
·
Harness or connector ·
Skid control buzzer assembly ·
Lane departure warning camera |
When the lane departure warning camera is replaced with a new one, adjustment of the lane departure warning camera beam axis must be performed.
Click hereEngine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>ADJUSTMENT
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the G74 skid control buzzer assembly connector.
Disconnect the Q13 lane departure warning camera connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G74-2 (IG1) - Body ground | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G74-1 (BZ) - Q13-8 (BZ) | Always | Below 1 Ω |
| G74-1 (BZ) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the skid control buzzer assembly.
Click hereEngine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT BUZZER>REMOVAL
Inspect the skid control buzzer assembly.
Click hereEngine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT BUZZER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG