Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT BUZZER
RM30B0U _51 Engine / Hybrid System _010069 CRUISE CONTROL _0060915 LANE DEPARTURE ALERT BUZZER A

CRUISE CONTROL  LANE DEPARTURE ALERT BUZZER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL

Hide 5.REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 6.REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 7.REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (w/ Radio Receiver)

Hide 8.REMOVE SKID CONTROL BUZZER ASSEMBLY (LANE DEPARTURE ALERT BUZZER)

B338919

a.

Detach the clamp.


b.

Disconnect the connector and remove the skid control buzzer (lane departure alert buzzer).